 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-2410-233-23
TRACK ROLLER FRAME ASSEMBLY REPLACEMENT - CONTINUED
0110 00
INSTALLATION
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use assistance
during procedure. Ensure that any lifting device used is in good condition and of suitable load
capacity. Keep clear of heavy parts supported only by lifting device. Failure to follow this
warning may cause injury or death.
Ratchet puller must be attached to track roller frame in a manner to evenly distribute weight
of frame. Failure to do so may cause frame to tip, causing personal injury or death.
NOTE
Weight of an assembled track roller frame is 4,000 lb (1,804 kg).
1.
Attach lifting device to rear of track roller frame (1).
2.
Place track roller frame (1) in position on track.
18
3.
Lift rear of track roller frame (1) in position on final
drive sprocket outer hub (18).
WARNING
1
Ratchet puller must be attached to track roller
frame in a manner to evenly distribute weight
386-222
of frame. Failure to do so may cause frame to
tip, which may cause injury or death.
4.
Attach lifting device to rear track carrier roller (10) and ratchet puller to lifting device and to recoil spring (11).
5.
Adjust ratchet puller so rear track carrier roller (10), rear support assembly (3) and recoil spring (11) are level and bal-
anced.
6.
Install cap (14) to track roller frame (1) with four new lockwashers (13) and capscrews (12). Tighten capscrews to 375
lb-ft (509 Nm).
7.
Install cap (17) to track roller frame (1) with four new lockwashers (16) and capscrews (15). Tighten capscrews to 375
lb-ft (509 Nm).
8.
Install pads (9) and plate (8) in position on track roller frame (1).
0110 00-4
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals