 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-2410-233-23
DRIVE SPROCKET SHAFT REPLACEMENT - CONTINUED
0103 00
INSTALLATION
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during pro-
cedure. Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of
heavy parts supported only by lifting device. Failure to follow this warning may result in injury or death.
CAUTION
Use caution and install sprocket shaft slowly to avoid damage to threads on shaft and in gear case.
NOTE
Sprocket shaft weighs approximately 200 lb (91 kg).
1.
Use a nylon sling and a suitable lifting device and position sprocket shaft (5) on bevel gear case (8).
2.
Push sprocket shaft (5) into bevel gear case (8) as far as possible using only hand pressure.
3.
Attach hydraulic pump for installation of sprocket shaft (5).
CAUTION
To avoid damage to bevel gear case threads, ensure adapters are installed in bevel gear case so that shoul-
der of adapter is against bevel gear case. After shoulder of adapter comes in contact with bevel gear case,
adapters can be tightened a maximum of 1/8 turn or loosened a maximum of 3/8 turn to put adapter in cor-
rect position so that remainder of tools can be installed. With all tools installed, do not let weight of tools or
lifting device put a load on adapters. Keep all tools level.
4.
Install two adapters (12) into large threaded holes in
bevel gear case (8).
5
13
14
15
5.
Install adapter (13) on end of sprocket shaft (5) and
connect rod (14) to adapter.
6.
Connect hydraulic cylinder (15) to adapters (12) in
bevel gear case (8).
12
386-292
8
0103 00-4
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals