 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-2410-233-23
FINAL DRIVE PINIONS AND FLANGES MAINTENANCE - CONTINUED
0101 00
INSTALLATION
1.
Apply silicone gasket forming compound on flange of bearing cage (4) and cage mounting surface on bevel gear case.
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during pro-
cedure. Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of
heavy parts supported only by lifting device. Failure to follow this warning may result in injury.
NOTE
Weight of final drive pinion and flange as a unit is 80 lb (36 kg).
2.
Use a nylon sling and a suitable lifting device to install
final drive pinion (6) and flange (1) as a unit on bevel
1
gear case. Ensure unit is positioned as follows:
a.
Engage unit with teeth on final drive gear inside
4
bevel gear case.
b.
Seat final drive pinion bearing race (14) in bear-
6
ing inside bevel gear case.
c.
Position bearing cage (4) flange with dowel hole
up, oil hole down and capscrew holes aligned
with holes in bevel gear case.
3.
Attach lifting equipment to track and move track to
align holes in flange (1) with holes in bearing cage (4).
386-544
NOTE
Flange may have to be rotated slightly to gain access to some capscrews.
4.
Install seven washers (5) and capscrews (3) to secure
3,5
4
bearing cage (4). Tighten capscrews to 100 lb-ft (136
Nm).
NOTE
If final drive pinion and flange were NOT disas-
sembled, skip step 5.
5.
Tighten nut (2) on shaft of final drive pinion (6) to 700
lb-ft (949 Nm).
6.
Bend lock (8) against nut (2).
7.
Install steering clutches (WP 0127 00).
8
8.
Run engine and test drive in all speeds (TM 5-2410-
233-10).
2
1
386-543
END OF WORK PACKAGE
0101 00-6
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals