 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-2410-233-23
0100 00
REMOVAL - CONTINUED
CAUTION
Use a piece of wire to keep idler pinion in position so it will not fall from steering clutch case when final
drive case is removed.
5.
Install a piece of wire (A) around two guide pins (4)
4
5
5
and across face of idler pinion to hold idler pinion in
place.
5
NOTE
Weight of final drive case is 280 lb (127 kg).
3
6.
Tighten three forcing screws (5) until two lifting links
4
can be attached to final drive case (3). Attach two lift-
ing links with 5/8 -11 x 2 in. bolts, nuts and washers to
final drive case (3).
7.
Attach a suitable lifting device to lifting links and
remove final drive case. Remove forcing screws.
A
386-535
NOTE
Plugs are destroyed during removal.
8.
If necessary to remove race and roller bearing assemblies (7 and 8), remove two plugs (9) from dowel holes in final
drive case (3) with a slide puller. Discard plugs.
9.
Use a #10-32 screw to remove dowel (10), holding race and roller assembly (7), from final drive case (3). Remove screw
from dowel.
10.
Use a 1/4 in. -20 NC capscrew to remove dowel (11),
8
holding race and roller assembly (8), from final drive
case (3). Remove capscrew from dowel.
11.
Pull race and roller assemblies (7 and 8) from final
drive case (3).
9,11
9,10
7
386-534
3
0100 00-3
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals