 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-2410-233-23
TRANSMISSION OIL LINES REPLACEMENT - CONTINUED
0088 00
REMOVAL
NOTE
This procedure provides general instructions for replacement of transmission oil lines. The examples
provided are typical examples only. The replacement of a specific line should vary only slightly.
CAUTION
Place protective caps or plugs on all transmission system openings to prevent foreign matter from
contaminating system.
NOTE
Use a suitable container to capture residual draining oil. Dispose of oil IAW local policy and
ordinances. Ensure all spills are cleaned up.
Tag lines before removal to ensure correct installation.
Hose clamp mounting hardware differs depending on location of clamp.
1.
Remove nuts (1), lockwashers (2), washers (3) and capscrews (4) from hose clamps (5) along entire length of line (6).
Discard lockwashers.
2.
If removing a line with a single or split flanged mounting, remove four capscrews (7), washers (8) and flange(s) (9) from
each end of line (6).
3.
Remove and discard O-ring (10) from each end of line (6).
4.
Remove line (6) from machine.
5.
If removing a line (11) that connects to a connector (12), disconnect each end of line from connector.
6.
Repeat step 1 as required to remove hose clamps (5) along entire length of line (11).
7.
Remove line (11) from machine.
12
11
7,8
6
1,2,3,4,5
9
LEFT SIDE OF ENGINE COMPARTMENT
386-772
10 (HIDDEN)
386-773
0088 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals