MAGNETIC STRAINER ASSEMBLY CLEANING AND INSPECTION

TM 5-2410-233-23

TRANSMISSION MAGNETIC STRAINER ASSEMBLY AND TORQUE

DIVIDER SUCTION SCREEN MAINTENANCE - CONTINUED

0085 00

MAGNETIC STRAINER ASSEMBLY CLEANING AND INSPECTION

NOTE

Dropping a magnet may result in demagnetization. Do not drop magnets.

Disassemble magnetic strainer (5) by removing tube

(6) and four magnets (7) from strainer.

Inspect strainer assembly for damage.

Inspect tube and magnets for metal shavings, particles

and damage. If metal shavings are found, contact

Direct Support Maintenance.

386-342

WARNING

Solvent cleaning compound MIL-PRF-680 Type III is an environmentally compliant and low

toxic material. However, it may be irritating to the eyes and skin. Use protective gloves and

goggles. Use in well-ventilated areas. Keep away from open flames and other sources of igni-

tion.

Particles blown by compressed air are hazardous. DO NOT exceed 15 psi (103 kPa) nozzle

pressure when drying parts with compressed air. Use a maximum of 30 psi (207 kPa) when

cleaning components. DO NOT direct compressed air against human skin. Failure to follow

this warning may result in serious injury or death. Make sure air stream is directed away

from user and other personnel in the area. To prevent injury, user must wear protective gog-

gles or face shield.

Clean components with solvent cleaning compound and dry using pressurized air.

0085 00-3