 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-2410-233-23
FLYWHEEL HOUSING MAINTENANCE - CONTINUED
0029 00
INSTALLATION
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during pro-
cedure. Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of
heavy parts supported only by lifting device. Failure to follow this warning may cause injury or death.
NOTE
Flywheel housing weighs approximately 350 lb (159 kg).
1.
Fasten lifting equipment to flywheel housing (6).
NOTE
Ensure all mating surfaces are clean and dry.
2.
Install new gasket (8) on flywheel housing (6).
3.
Use lifting equipment to place flywheel housing (6) in
position against cylinder block.
4.
Install 13 capscrews (7) to hold flywheel housing (6)
in place. Ensure two shorter capscrews go into posi-
tions 7 and 2.
5.
Tighten 13 capscrews (7) in number sequence shown
to 75 lb-ft (102 Nm).
TIGHTENING SEQUENCE
386-198
6.
Cut gasket (8) even with oil pan face of cylinder block.
0029 00-3
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals