 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-2410-233-23
FLYWHEEL HOUSING MAINTENANCE - CONTINUED
0029 00
REMOVAL - CONTINUED
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during pro-
cedure. Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of
heavy parts supported only by lifting device. Failure to follow this warning may cause injury or death.
NOTE
Flywheel housing weighs approximately 350 lb (159 kg).
4.
Fasten lifting equipment to flywheel housing (6).
5.
Remove 13 capscrews (7) that hold flywheel housing
16
14
12 11
13
9
15
(6) in place.
6.
Remove flywheel housing (6).
8
7.
Remove and discard gasket (8) from flywheel housing
17
10
(6).
DISASSEMBLY
18
1.
Remove rear accessory drive gears (WP 0035 00).
2.
Remove mounting brackets from each side of fly-
wheel housing (WP 0029 00).
3.
Remove plug (9), if required.
4.
Remove plug (10), if required.
7
5.
Remove four capscrews (11), cover (12) and gasket
(13). Discard gasket.
19
6.
Remove two washers (14) and pins (15).
7.
Use a bearing puller to remove two bearings (16).
386-102
6
8.
If necessary, remove dowels (17 and 18) and stud (19)
from flywheel housing (6).
ASSEMBLY
1.
If removed, install dowels (17 and 18) and stud (19) into housing (6). Tighten studs to 40 lb-ft (54 Nm).
2.
Apply grease to two bearings (16) and with suitable driving tool, install bearings.
3.
Install two washers (14) and pins (15).
4.
Install cover (12) and new gasket (13) with four capscrews (11).
5.
If removed, install plug (10).
6.
If removed, install plug (9).
7.
Install mounting brackets on each side of flywheel housing (6) (WP 0029 00).
8.
Install rear accessory drive gears (WP 0035 00).
0029 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals