REMOVAL - TM-5-2410-233-230202

TM 5-2410-233-23

FLYWHEEL ASSEMBLY REPLACEMENT - CONTINUED

0028 00

REMOVAL

WARNING

Use extreme caution when handling heavy parts. Provide adequate support and use assistance during pro-

cedure. Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of

heavy parts supported only by lifting device. Failure to follow this warning may cause injury or death.

NOTE

Some flywheel assemblies come from the manufacturer without drilled and tapped holes for installing lift-

ing equipment. If flywheel assembly to be removed or replaced is missing drilled holes, contact your local

Caterpillar dealer for assistance.

NOTE

Flywheel assembly weighs 125 lb (57 kg).

Remove seven capscrews (1) and washers (2) from flywheel assembly (3).

Install two 5/8 in. -18NF guide bolts in crankshaft.

1,2

Remove two remaining capscrews (1) and washers

(2).

Slide flywheel assembly (3) out on guide bolts until

flywheel is sufficiently clear to install lifting equip-

ment.

Fasten lifting equipment to flywheel assembly (3).

NOTE

Keep flywheel level during removal to prevent

hydraulic pump gear from falling off front of

flywheel.

Lift flywheel assembly (3) clear and remove.

386-196

0028 00-2