Lamp(s) Will Not Light.- Continued - TM-5-2410-233-230096

TM 5-2410-233-23

TROUBLESHOOTING PROCEDURES - CONTINUED

0006 00

Table 6. Electrical System Troubleshooting Procedures - Continued.

MALFUNCTION

TEST OR INSPECTION

CORRECTIVE ACTION

3. Check for corrosion or dirt in 1. Clean corroded connections.

13. Lamp(s) Will Not Light - Continued.

sockets or on terminals.

2. Clean dirt and rust from

sockets and terminals.

4. Check lamp holders for loose 1. Tighten all loose connections.

connections and broken wire

terminals.

2. Repair or replace broken wire

NOTE

For headlamps or rear lamps, go to Table 6, Malfunction 13,

Test 5. For dash lamps, go to Table 6, Malfunction 13, Test 7.

5. Test headlamp/rear flood-

lamp circuit.

a. Place battery disconnect

switch in OFF position.

NOTE

If any of the following conditions exist, replace or repair bro-

ken wire between lamp and 15 amp fuse or between lamp

and ground.

One headlamp only will not light.

Both headlamps only will not light.

Rear floodlamp only will not light.

b. If none of the exterior

floodlamps light, go to

Step c.

0006 00-48