Torque Divider Overheats

TM 5-2410-233-23

TROUBLESHOOTING PROCEDURES - CONTINUED

0006 00

Table 2. Transmission Troubleshooting Procedures - Continued.

MALFUNCTION

TEST OR INSPECTION

CORRECTIVE ACTION

10. Torque Divider Overheats (According to 1. Check transmission oil level.

Add oil as required (WP 0086

00).

Converter Oil Temperature Gage).

2. Check V-belts.

Adjust V-belt tension or replace

V-belts (WP 0069 00).

3. Check converter oil temp- Replace faulty oil temperature

erature gage for proper gage.

operation using a gage known

to be good.

4. Check for loose or damaged Tighten loose lines and fittings.

oil lines.

Replace damaged oil line(s) (WP

0088 00).

5. Check for obstruction at Clean or replace breathers (WP

transmission breathers.

0099 00).

6. Check for excessive oil in 1. Clean torque divider junction

engine flywheel housing and

screen (WP 0085 00).

torque divider cover.

2. Replace

torque

divider

scavenge pump (WP 0097 00).

3. Replace torque divider (WP

0092 00).

7. Perform transmission and 1. Adjust outlet relief valve(s)

torque converter pressure

(WP 0094 00).

tests (WP 0096 00).

2. Replace transmission oil pump

if pressures are still not within

required limits (WP 0095 00).

8. Check transmission oil cooler Replace transmission oil cooler

for leaks or damage.

(WP 0087 00).

1. Check for oil around torque Replace cover gasket,

11. Loss of Torque Divider Oil.

divider scavenge pump cover necessary (WP 0095 00).

gasket.

2. Check for oil around flywheel Replace flywheel housing-to-

housing-to-torque

divider torque divider housing cover

cover area.

gasket (WP 092 00).

3. Check for oil around torque Replace output shaft seal, if

divider output shaft.

necessary (WP 0091 00) or

replace torque divider (WP 0091

01).

4. Check for oil around flywheel Replace

leaking

flywheel

housing-to-engine block area. housing-to-engine block gasket

(WP 0029 00).

0006 00-16