ADJUSTMENT - TM-5-2410-233-100144

TM 5-2410-233-10

TRACK ADJUSTMENT - CONTINUED

0015 00

ADJUSTMENT - CONTINUED

WARNING

Wear eye protection and keep face clear when venting grease from relief valve during track adjustment.

NEVER visually inspect relief valve to see if grease is escaping. Always observe track to verify it has loos-

ened. Failure to follow this warning could cause eye injury or blindness.

NOTE

If track tension does not release, notify Unit Maintenance.

Open relief valve and allow grease to escape and track tension to release.

Close relief valve. Clean area around fill and relief valves.

FILL VALVE

COVER

386-717

Fill grease gun and connect to fill valve.

Pump grease into fill valve until track idler moves forward toward front of tractor. STOP pumping when track idler stops

moving.

Mark a line on track roller frame 1/2 in. (13 mm) from rear face of idler bearing support.

WARNING

Wear eye protection and keep face clear when venting grease from relief valve during track adjustment.

NEVER visually inspect relief valve to see if grease is escaping. Always observe track to verify it has loos-

ened. Failure to follow this warning could cause eye injury or blindness.

Open relief valve no more than one turn and allow grease to escape and idler to move back.

0015 00-2