Accelerator and Choke Linkages

(4) Unhook spring (2) from clip at carburetor

4-40. Accelerator and Choke Linkages

mounting stud and pin (6).

a. Throttle Linkage Removal.

(5) Remove clip (3) and pin (6) and remove

(1) Open left and right sides of hood.

cross shaft to carburetor rod (4) with assembled

(2) Remove two cotter pins (10, fig. 4-18) and

clevis (7), Loosen nut (5), and remove clevis (7)

flat washers (14) and remove pedal to cross shaft

and nut (5) from rod.

rod (11).

(6) Remove two screws (9) and nuts (8), and

(3) Remove screws (15) and nuts (12), and

remove cross shaft (1) from engine compartment.

remove pedal (13).

Figure 4-18. Carburetor linkage. exploded view.

b. Installation. Reverse procedure in a a b o v e .

carburetor choke lever to release choke cable (fig.

c. Adjustment.

4-13).

(1) With linkage installed, unsnap clip (3) and

(2) Loosen screw in choke cable clamp.

remove rod (4) from carburetor throttle lever.

(3) Remove nut and washer securing choke

(2) Fully depress pedal (13) and move car-

cable from engine compartment side of fire wall

buretor throttle lever by hand to full throttle.

and pull out choke cable.

(3) Loosen nut (5) and turn rod (4) in or out of

e. Installation. Reverse procedure in d a b o v e .

clevis (7) until rod end can be inserted through

f. Adjustment. With choke cable installed,

carburetor throttle lever. Secure with clip (3).

depress knob, fully open choke valve on carburetor

(4) Release pedal (13) and adjust carburetor if

b y hand and secure cable to choke lever with

necessary for proper idle speed (para 4-36 a (2)).

locking screw swivel nut.

d. Choke Cable Removal.

(1) Loosen clamping screw and swivel nut at