RECORDING AND REPORTING THE MODIFICATION.

Install warning decal P/N 12300572 next to new instruction and data plate.

n. Change tire pressure markings on both left and right side fenders to read

TP-105, in accordance with TB-43-0209.

11.

CALIBRATION REQUIREMENTS. Not applicable

Weight and balance are not significantly affected.

WEIGHT AND BALANCE DATA.

12.

13. QUALITY ASSURANCE REQUIREMENTS. Not applicable.

RECORDING AND REPORTING THE MODIFICATION.

14.

a. Records and Reports Forms.

R e c o r d the modification on DA Form

(1) DA Form 2408-5 or DA Form 2409.

2 4 0 8 - 5 , Equipment Modification Record, when multiple form assembled

E q u i p m e n t L o g b o o k i s a p p l i c a b l e , or DA Form 2409, Equipment Maintenance

Log (Consolidated).

( 2 ) Completion of DA Form 2407, Maintenance Request. The serial number to be

reported in Block 2 must be in the serial range stated in paragraph 3 of

the MWO. T h e NSN for components, assemblies, and subassemblies to be

r e p o r t e d in Block 6 must be the same as the NSN shown in paragraphs 4 and

5 . T h e NSN of the item actually modified will be entered in Block 20h.

T h i s NSN must match the NSN shown in Block 6. The UIC to be reported in

B l o c k 1C m u s t b e t h e s i x c h a r a c t e r c o d e t h a t i s p u t o n t h e U n i t /

(Normally, this will be the code that is

Organization shown in Block la.

put on the Unit/Organization Morning Report.) List by NSN the number of

k i t s used to accomplish this MWO using Block 20 and/or Block 35. If more

s p a c e is needed , u s e D A 2 4 0 7 - 1 , C o n t i n u a t i o n S h e e t . A f t e r c o m p l e t i n g t h e

Commander, US Army Tank-Automotive

f o r m , mail the NMP copy (Copy 2) to:

Command ATTN: D R S T A - M R P , Warren, MI 48090. Mail the control Copy (Copy

3 ) t o : Commander, US Army Depot System Command, ATTN: DRSDS-PM,

C h a m b e r s b u r g , PA 17201, for PAC 98 (Non-AIF Field Activities). Forward

t h e O r g a n i z a t i o n a l C o p y (C o p y 4) a s d i r e c t e d by l o c a l com m a n d e r . S e e

Appendix C for examples of DA Form 2407.

(3) DA Form 2408-9. Not applicable.

Marking

Equipment.

( 1 ) Mark the equipment by stamping " M W O 9-2320-260-30-1" in a conspicuous

location near the identification plate of the end item modified.

(2) A new data plate is furnished as part of the modification kit. The new

data plate replaces the old data plate.

(3) A warning decal is furnished as part of the modification kit. This decal

is installed on inside of left cab door.