 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 NOTES:
1. ARMY OIL ANALYSIS PROGRAM
transmission
in
neutral.
Maintain
level
(AOAP). For Active Army units, obtain
between full and add mark on engine run-
samples from engine and automatic
ning side of gage.
transmission every 50 hours of operation
5. ENGINE. Oil iS to be c h a n g e d e a c h
or 60 days (whichever comes first).
Reserve and National Guard activities
time
an
engine
oil
change
is
directed
by
will use 50 hours or 120 days as the
AOAP
Iaboratory.
When
AOAP
laboratory
prescribed sample intervals. Reserve and
support is not available, change oil each
National Guard equipment in frequent
100 hours. Drain Iubricant when warm.
use during active training period will
adhere to the schedule for Active Army
6. ENGINE OIL FILTERS. Filters are to be
units. As a minimum, one sample from
replaced each time an engine oil change
each unit's two week active training
is directed by AOAP laboratory. After in-
new filter elements, fill
period will be submitted for each item of
stalling
equipment. Send these samples to the
crankcase, operate engine 5 minutes,
nearest AOAP laboratory. Refer to TB
check housings for leaks, check
43-0210 for sampling instructions. When
crankcase oil level and bring to full mark.
When AOAP laboratory support is not
or if AOAP laboratory support
is
unavailable, hard time intervals will app-
available. install new filter elements each
ly.
100 hours.
NOTE
7. TRANSMISSION, BEVEL GEAR, AND
STEERING CLUTCH COMPARTMENT.
Do not hold oil samples. Submit
Check level each 10 hours with engine
oil samples as soon as they have
running at idle speed, oil at operating
been taken.
temperature and transmission in neutral.
Maintain oil level to "FULL" mark. Oil is
Seasonal oil changes will be made
to be changed each time a transmission
due to expected temperatures.
is directed by AOAP
oil change
(See Key.)
laboratory,
Remove transmission
magnetic strainer, clean and replace us-
2. FOR OPERATION OF EQUIPMENT IN
ing new gasket. Fill transmission to low
PROTRACTED COLD TEMPERATURES
mark. Run engine at idle speed to fill con-
BELOW -15F (-26C). Remove lubricants
verter and lines. Add oil to bring level to
prescribed in Key for temperatures above
low mark. With engine running at idle
-15F (-26C). Relubricate with lubricants
speed, oil at operating temperature and
specified in Key for temperatures below
transmission in neutral, add oil to bring
-15F (-26C). If OEA lubricant is required
oil level to "FULL" mark. Operate for 5
to meet the temperature ranges prescrib-
minutes and check for leaks. When AOAP
ed in the Key, OEA lubricant is to be used
laboratory support is not available,
in place of OE/HDO-10 lubricant for all
change transmission oil each 1000 hours.
temperature ranges where OE/HDO-10 is
specified in the Key.
8. TRANSMISSION OIL FILTER. Filter ele-
3. OIL CAN POINTS. Each 50 hours
ment is to be replaced each time a
lubricate clutch pedal linkage, transmis-
transmission oil change is directed by
sion shift linkage, transmission shift
AOAP laboratory. Remove filter element,
clean filter housing, install new filter ele-
linkage, pins and clevises, and all expos-
ed adjusting threads, hinges, handles
ment and seal. After replacement, fill
and wear points with OE/HDO.
transmission to low mark. With engine
running, oil at operating temperature and
4. ENGINE OIL LEVEL. Check with engine
transmission in neutral, add oil to bring
running at idle speed, oil warm and
oil level to, "FULL" mark. Operate for 5
I
TA 218824
LO 5-2410-233-12
CARD 6 OF 7
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals