 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-363-20-2
AIR COMPRESSOR REPLACEMENT (CONT)
5.
APPLY LIGHT COATING OF GAA TO BOLT HOLE LOCATIONS ON NEW GASKET (10) AND INSTALL GASKET
ON AIR COMPRESSOR (5).
WARNING
Engine components are heavy. Use extreme caution during installation of large
engine components to prevent injury to personnel.
6.
SLIDE AIR COMPRESSOR (5) OVER THREADED STUD (11) AND INSTALL NUT (12). HAND TIGHTEN NUT.
7.
INSTALL FOUR BOLTS (13) AND BOLT (14) AND HAND TIGHTEN.
8.
TORQUE NUT (12), FOUR BOLTS (13), AND BOLT (14) TO 75-93 LB-FT (101-126 N.m).
9.
INSTALL SUPPORT BRACKET (15) AND TWO BOLTS (16). HAND TIGHTEN BOLTS (16).
10.
INSTALL TWO BOLTS (17) AND TORQUE TO 43-54 LB-FT (58-73 N.m).
11.
TORQUE TWO BOLTS (16) TO 13-17 LB-FT (18-23 N.m).
12.
INSTALL ELBOW (18) ON ENGINE BLOCK (19).
13.
SLIDE TWO HOSE CLAMPS (20) ONTO COOLANT INLET HOSE (21).
14.
CONNECT COOLANT INLET HOSE (21) TO ELBOW (18) AND ELBOW (4).
15.
SLIDE A HOSE CLAMP (20) TO EACH END OF COOLANT INLET HOSE (21) AND TIGHTEN.
16.
CONNECT OIL SUPPLY HOSE (22) TO ELBOW (3).
17.
SLIDE HOSE CLAMP (23) ONTO COOLANT OUTLET HOSE (24) AND CONNECT COOLANT OUTLET HOSE
(24) TO ELBOW (2). TIGHTEN HOSE CLAMP (23).
18.
SLIDE HOSE CLAMP (25) ONTO AIR INLET HOSE (26) AND CONNECT AIR INLET HOSE (26) TO ELBOW (7).
TIGHTEN HOSE CLAMP (25).
19.
CONNECT AIR SUPPLY HOSE (27) TO ELBOW (1).
4-27.4 Change 3
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals