 |
|||
|
|
|||
|
Page Title:
PLANETARY GEARING, SHAFTS, AND THIRD CLUTCH REPAIR (CONT) |
|
||
| ||||||||||
|
|
 TM 9-2320-360-34-2
NOTE
Do steps (4) thru (10) only if end play
is not within specifications.
(4) Drill away staked ends of four spindles (5)
using 5/8 in. (16 mm) bit.
(5) Place center carrier assembly (1) in press.
(6) Press four spindles (5) from center carrier
assembly (1). Discard spindles.
(7) Remove front carrier assembly (1) from
press.
NOTE
Some transmissions will have a
single graphite filled polyamide
thrust washer in place of the
combination of bronze and steel
thrust washers.
(8) Remove four spur gears (2), eight bronze
thrust washers (3), and eight steel thrust
washers (6) from center carrier assembly
(1).
(9) Remove eight roller bearings (7) from
pinions (2).
(10) Remove bushing (8) from center carrier
assembly (1).
Rear Carrier
(1) Place rear carrier assembly (1) on flat
work surface with splined hub up.
(2) Inspect rear carrier assembly (1) for
excessive wear, damage, or heavy metal
(3) Check end play of pinions (2 and 3). With
thrust washer (4 and 5) held flat, insert
feeler gage (6) between rear carrier
assembly (1) and thrust washers (4 and
5). End play must be within 0.008-0.031
in. (0.21-0.78 mm).
Change 3 22-87
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals