 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-364-34-1
C-25. TURBOCHARGER HOLDING FIXTURE.
Fabricate from 3/4 in. (19 mm) exterior grade plywood.
Drill 1 1/2 in (38 mm) diameter hole in center of base.
a.
Drill four 1/2 in. (13 mm) diameter holes in corners of base.
b.
Draw a circle with a 1 5/8 in. (41 mm) radius.
c.
Route four 1/2 in. (13 mm) x 3/4 in. (19 mm) slots in base into circle as shown.
d.
Fabricate two 1 15/16 in. (49 mm) x 2 1/2 in (63.5 mm) x 1 1/4 in. (32 mm) fingers from plywood.
e.
Grind bottom of fingers 23/32 in. (18 mm) wide and 7/16 in. (11 mm) high. Contour front surface of fingers to
f.
fit turbine wheel blades.
C-26
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals