 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-363-20-2
SEAT ASSEMBLY REPAIR (CONT)
CLEANING/INSPECTION
Clean and inspect all parts in accordance with Chapter 2.
ASSEMBLY
1.
INSTALL TWO RUBBER BUMPERS (1) TO RISER (2).
2.
PRESS TWO BEARINGS (3) INTO LEVER (4) WITH FLANGES OF BEARINGS ON OUTSIDE OF LEVER.
3.
INSTALL LEVER (5) TO LEVER (4) WITH TWO SHOULDER BOLTS (6) AND NUTS (7). TIGHTEN NUTS TO 16
TO 20 LB-FT (22 TO 27 N.m).
4.
INSTALL TWO SLIDE BLOCKS (8) ON REAR OF LEVER (5) AND TWO BEARING BLOCKS (9) ON FRONT OF
LEVER (4).
5.
INSTALL LEVER (4 AND 5) ASSEMBLY INTO RISER (2) AND INSTALL TWO SCREWS (10) INTO BEARING
BLOCKS (9).
6.
INSTALL TWO SPACERS (11) AND SLIDE BLOCKS (12) ON ENDS OF LEVER (4) AND TWO BEARING BLOCKS
(13) ON ENDS OF LEVER (5).
7.
INSTALL UPPER PLATE (14) OVER BEARING BLOCKS (13) AND SLIDE BLOCKS (12).
8.
INSTALL TWO SCREWS (15) TO BEARING BLOCKS (13).
9.
USE BLOCKING BETWEEN UPPER PLATE (14) AND RISER (2) TO HOLD UPPER PLATE IN FULLY RAISED
POSITION.
10.
AT REAR OF RISER (2), INSTALL TWO STOP BLOCKS (16) WITH TWO SCREWS (17).
NOTE
Perform steps 11 and 12 to install damper.
11.
PRESS TWO BEARINGS (18) INTO DAMPER (19).
12.
INSTALL DAMPER (19) TO RISER (2) AND LEVER (4) WITH TWO WASHERS (20) AND NEW PUSH-ON
FASTENERS (21).
NOTE
Perform steps 13 thru 15 to install air spring.
13.
POSITION AIR SPRING (22) WITH FITTING FACING FORWARD.
14.
INSTALL AIR SPRING (22) WITH WASHER (23), SCREW (24) AND SCREW (25). TIGHTEN SCREW (25) TO 15
TO 19 LB-FT (20.3 TO 25.7 N.m). TIGHTEN SCREW (24) TO 9 TO 11 LB-FT (12 TO 15 N.m).
15.
CONNECT AIR LINE (26) TO AIR SPRING (22).
4-695.6 Change 3
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals