 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM
9-2320-363-20-2
INSTALL INNER WHEEL BEARING (4) IN HUB (2).
4.
INSTALL NEW OIL SEAL (5) IN HUB (2).
5.
INSTALL HUB (2) ON AXLE SPINDLE (6) AND FILL CAVITY WITH AXLE OIL.
6.
7.
COAT OUTER WHEEL BEARING (7) WITH AXLE OIL.
INSTALL OUTER WHEEL BEARING (7) IN HUB (2).
0.
NOTE
Adjusting nut can be identified by protrusion on one side.
WITH PROTRUSION FACING OUT, INSTALL ADJUSTING NUT (8) UNTIL ADJUSTING NUT
9.
..
CONTACTS OUTER WHEEL BEARING (7).
CAUTION
Hub must be rotated in both directions while tightening adjusting nut. Failure
to do so will result in premature bearing failure.
10.
TIGHTEN ADJUSTING NUT (8) TO 100 LB-FT (136 Nm).
11.
LOOSEN ADJUSTING NUT (8) COMPLETELY AND TIGHTEN TO 50 LB-FT (68 Nm).
12.
LOOSEN ADJUSTING NUT (8) 1/4 TURN.
NOTE
During step 13, it may be necessary to tighten adjusting nut to aline protrusion
w i t h alinement hole in lock ring.
13.
INSTALL LOCK RING (9) ON AXLE SPINDLE (6).
14.
INSTALL JAM NUT (10) ON AXLE SPINDLE (6). TIGHTEN JAM NUT TO 250-400 LB-FT (339-542 Nm).
15.
INSTALL NEW GASKET (11) ON STUDS (3).
NOTE
Splines on axle shaft must engage in differential before axle flange will seat
a g a i n s t hub.
16.
COAT EIGHT TAPERED DOWELS (12) WITH ANTISEIZE COMPOUND.
17.
INSTALL AXLE SHAFT (13), EIGHT TAPERED DOWELS (12), EIGHT NEW LOCK WASHERS (14),
AND EIGHT NUTS (15). TIGHTEN NUTS TO 155 LB-FT (210 Nm).
18.
INSTALL BRAKE DRUM (16) ON HUB (2).
4-603
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals