Removal (Cont) -699580827

9-2320-363-20-2

CAUTION

M a k e sure axle hub studs are not damaged during axle shaft removal. If

damage occurs, replace stud to allow proper installation of tapered dowels

and nuts.

USING SLEDGE HAMMER, SHARPLY STRIKE CENTER OF AXLE SHAW (5) UNTIL SEAL TO HUB

(2) IS BROKEN AND EIGHT TAPERED DOWELS (6) ARE LOOSENED.

REMOVE EIGHT TAPERED DOWELS (6), AXLE SHAW (5), AND GASKET (7). DISCARD GASKET.

REMOVE JAM NUT (8), LOCK RING (9), AND ADJUSTING NUT (10) FROM AXLE SPINDLE (11).

REMOVE OUTER WHEEL BEARING (12) FROM AXLE SPINDLE (11).

REMOVE HUB (2) FROM AXLE SPINDLE (11).

REMOVE AND DISCARD OIL SEAL (13) FROM HUB (2).

REMOVE INNER WHEEL BEARING (14) FROM HUB (2).

10. IF DAMAGED, REMOVE EIGHT STUDS (15) FROM HUB (2).

NOTE

Perform step 11 only after performing step 1 of Cleaning/Inspection, and only if

b e a r i n g s are damaged.

11. USING BRASS DRIFT PIN, CAREFULLY REMOVE AND DISCARD TWO BEARING CUPS (16) FROM

HUB (2).

CLEANING/INSPECTION

INSPECT BEARINGS IN ACCORDANCE WITH TM 9-214. IF BEARING(S) ARE DAMAGED,

PERFORM STEP 11 OF REMOVAL.

CLEAN AND INSPECT ALL OTHER PARTS IN ACCORDANCE WITH CHAPTER 2.

4-601