INSTALLATION (Cont) -699580596

TM 9-2320-363-20-2

DRIVELINE U-JOINT AND DUST CAP REPLACEMENT (CONT)

INSTALL UNIVERSAL JOINT (6) IN FLANGE YOKE (7).

CAUTION

Be careful when installing bearing caps, or needle bearings may fall out and be

damaged or lost.

NOTE

Make sure bearing caps are seated against flange yoke.

INSTALL TWO BEARING CAPS (8) ON EACH SIDE OF FLANGE YOKE (7) AND UNIVERSAL JOINT (6).

NOTE

M916A2, M917A1, and M917A1 w/MCS drivelines are not equipped with lockstraps.

INSTALL LOCKSTRAPS (9) AND TWO SCREWS (10) ON BEARING CAPS (8). TIGHTEN SCREWS TO 28 LB-

FT (38 N.m) FOR M916A2, M917A1, AND M917A1 W/MCS. TIGHTEN SCREWS TO 33-38 LB-FT (44-52 N.m)

FOR M916A1.

BEND TABS ON LOCKSTRAPS (9) AROUND SCREWS (10).

NOTE

Follow-on Maintenance:

Install drivelines (page 4-386 or 4-388).

Lubricate driveline and universal joint (Unit PMCS, TM 9-2320-363-20-1).

4-394 Change 3