 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-363-20-2
WARNING
Do not get under vehicle unless vehicle is supported by jack stands. To
do so could result in serious injury to personnel.
NOTE
Procedure is the same for all drivelines.
1.
BEND TABS ON LOCKSTRAPS (1) ON BOTH SIDES OF FLANGE YOKE (2) AWAY FROM
SCREWS (3).
2.
REMOVE TWO SCREWS (3) AND LOCKSTRAP (1) FROM EACH SIDE OF FLANGE YOKE (2).
CAUTION
Be careful when removing bearing caps, or needle bearings may fall out
and be damaged or lost.
3.
REMOVE BEARING CAPS (4) FROM EACH SIDE OF FLANGE YOKE (2) AND UNIVERSAL
JOINT (5).
WARNING
Drivelines are heavy. Use extreme caution during removal of drivelines
to prevent injury to personnel.
4.
PULL DRIVELINE (6) TO ONE SIDE AND PULL OUT TO REMOVE DRIVELINE (6) FROM
FLANGE YOKE (2).
CLEANING/INSPECTION
Clean and inspect all parts in accordance with Chapter 2.
INSTALLATION
WARNING
Do not get under vehicle unless vehicle is supported by jack stands.
To do so could result in serious injury to personnel.
Drivelines are heavy. Use extreme caution during installation of
drivelines to prevent injury to personnel.
NOTE
Procedure is the same for all drivelines.
1.
INSTALL UNIVERSAL JOINT (5) IN FLANGE YOKE (2).
Change 4
4-387
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals