 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-363-20-2
CLEANING/INSPECTION
Clean and inspect all parts in accordance with Chapter 2.
INSTALLATION
WARNING
Install seal clamps only hand-tight until all exhaust pipes are installed and
tightened down. Failure to do so will cause exhaust leaks and can result in serious
personnel injury.
1.
INSTALL NEW SEAL CLAMP (1) AND MUFFLER INLET PIPE (2) ON MUFFLER (3).
NOTE
Install quantity of washers noted during removal step 8.
2.
INSTALL SADDLE CLAMP (4), WASHER(S) (5), AND TWO NUTS (6).
3.
INSTALL TWO BRACKETS (7), TWO WASHERS (8), TWO SCREWS (9), TWO WASHERS (10), AND TWO NUTS
(11) ON FRAME RAIL (12).
4.
INSTALL TWO SADDLE CLAMPS (13), PIPE (14), AND FOUR NUTS (15) LOOSELY ON TWO BRACKETS (7).
5.
INSTALL NEW SEAL CLAMP (16), FLEX PIPE (17), NEW SEAL CLAMP (18), PIPE ELBOW (19), AND NEW
SEAL CLAMP (20).
5.1.
INSTA LL HEAT SHIELD (20.1) AND CLAMP (20.2).
6.
INSTALL NEW SEAL CLAMP (21), FLEX PIPE (22), NEW SEAL CLAMP (23), EXHAUST OUTLET PIPE (24), AND
CLAMP (25).
7.
TIGHTEN FOUR NUTS (15).
8.
TIGHTEN ALL SEAL CLAMPS (1, 16, 18, 20, 21, AND 23) IN THREE INCREMENTS TO 33 LB-FT (45 N.m).
Change 3 4-97
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals