 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-363-20-2
ETHER STARTING AID REPLACEMENT (CONT)
CLEANING/INSPECTION
Clean and inspect all parts in accordance with Chapter 2.
INSTALLATION
1.
IF REMOVED, INSTALL TWO SPACERS (1), NEW STARTING AID MOUNTING BRACKET (2), TWO
SCREWS (3), AND TWO NEW LOCK NUTS (4) ON FRAME RAIL (5).
2.
IF REMOVED, INSTALL NEW TUBE (6), CLAMP (7), AND SCREW (8).
INSTALL CAP (9) IN VALVE (10).
3.
INSTALL VALVE (10) IN STARTING AID MOUNTING BRACKET (2) AND TIGHTEN TWO SCREWS
4.
(11).
INSTALL CONNECTOR (12) IN VALVE (10).
5.
6.
INSTALL SCREW (13), WIRE (14), CLAMP (15), WASHER (16), AND NEW LOCK NUT (17) ON
STARTING AID MOUNTING BRACKET (2).
7.
INSTALL CLAMP (18), TWO STUD AND NUT ASSEMBLIES (19), TWO NEW LOCK WASHERS (20),
AND TWO NUTS (21 ) ON STARTING AID MOUNTING BRACKET (2).
INSTALL SADDLE (22), TWO NEW LOCK WASHERS (23), AND TWO WING NUTS (24).
8.
INSTALL BUSHING (25) IN INTAKE MANIFOLD (26).
9.
10. CONNECT ATOMIZER (27) TO BUSHING (25).
11. CONNECT TUBE (6) TO ATOMIZER (27).
12. CONNECT CONNECTOR (28) TO HARNESS (29).
13. CONNECT TUBE (6) TO CONNECTOR (12).
NOTE
Follow-on Maintenance:
I n s t a l l ether starting aid fuel cylinder (page 4-74).
C o n n e c t batteries (page 2-29).
4-72
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals