 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-360-34-2
28-2. WINCH REPAIR (CONT)
WARNING
Wear eye protection and use care
when installing retaining rings.
Retaining rings are under spring
tension and can act as projectiles
when released causing severe eye
injury.
NOTE
Right and left sides are assembled
the same way. Left side is shown.
(4) Install new retaining ring (7) in gear end
support (8).
WARNING
Adhesive-sealant may burn or give
off harmful vapors. It is harmful to
skin and clothing. To avoid injury or
death, keep away from open flame
and use in well-ventilated area. If
adhesive-sealant gets on skin or
clothing, wash immediately with soap
and water.
NOTE
Do steps (4.1) thru (6) if bushings
failed inspection.
(4.1) Coat outside face of bushing (9) and
bushing (10) with adhesive-sealant (Item
10.1, Appendix B).
(5) Install large bushing (9) in gear end
support (8).
(6) Install small bushing (10) in gear end
support (8).
(7) Install new seal ring (11) in gear end
support (8).
(8) Install new retaining ring (12) in motor end
support (13).
NOTE
Do steps (8.1) thru (10) if bushings
failed inspection.
(8.1) Coat outside face of bushing (14) and
bushing (15) with adhesive-sealant (Item
10.1, Appendix B).
(9) Install large bushing (14) in motor end
support (13).
(10) Install small bushing (15) in motor end
support (13).
(11) Install new seal ring (16) in motor end
support (13).
28-18 Change 1
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals