|
|
TM 9-2320-360-34-2
27-2. STEERING PUMP REPAIR
This task covers:
Disassembly
Assembly
Cleaning/Inspection
INITIAL SETUP
Equipment Conditions
Materials/Parts
Steering pump on clean work surface.
Adhesive-Sealant (Item 5, Appendix B)
Tape, Plastic (Item 59, Appendix B)
Gaskets (2) (Item 24, Appendix F)
Tools and Special Tools
Tool Kit, Genl Mech (Item 202, Appendix E)
Gaskets (2) (Item 26, Appendix F)
Caliper Set, Micrometer (Item 15, Appendix E)
Packings, Preformed (8) (Item 169, Appendix
Caps, Vise Jaw (Item 17, Appendix E)
Packings , Preformed (4) (Item 172, Appendix
Compressor Unit, Air (Item 24, Appendix E)
Packings, Preformed (2) (Item 170, Appendix
Goggles, Industrial (Item 57, Appendix E)
Packings, Preformed (2) (Item 171, Appendix
Nut, 5/8 In. (Item 101, Appendix E)
Packings, Preformed (2) (Item 184, Appendix
Pliers, Retaining Ring (Item 108, Appendix E)
Packings, Preformed (2) (Item 187, Appendix
Press, Hydraulic (item 116, Appendix E)
Packing, Preformed (Item 185, Appendix F)
Puller Kit, Mechanical, Gear and Brg
Rings, Retaining (2) (Item 234, Appendix F)
(Item 124, Appendix E)
Seals, Oil (2) (Item 311, Appendix F)
Screw, 5/8 x 4-1/2 In. (Item 149, Appendix E)
Socket, Power Steering (item 166, Appendix E)
Vise, Machinist's (Item 207, Appendix E)
Washers, Fiat, 5/8 In. (4) (Item 209, Appendix E)
Wrench Set, Socket, 3/4 In. Drive (Item 231,
Wrench, Torque, 0-300 Lb-in. (Item 235,
Wrench, Torque, 0-175 Lb-Ft (Item 236,
NOTE
Steering pump consists
of
two
similar housings.
a. Rear Housing Disassembly
(1) Remove shipping plug (1) from valve
block (2).
(2) Remove hose (3) from elbow (4).
(3) Remove hose (3) from fitting (5).
(4) Remove elbow (4) and preformed packing
(6) from compensator body (7). Discard
preformed packing.
(5) Remove four screws (8), compensator
body (7), gasket (9), and preformed
packing (10) from valve block (2). Discard
preformed
packing
and
gasket.
27-2
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |