 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-360-34-2
(39)
Install shift collar (39) with larger taper up
on input shaft (29).
(40)
Coat two needle bearings (37) with
grease.
(41)
Install large gear (40) over top input shaft
(29) with collar gears facing down.
(42)
Install spacer (41) over top input shaft
(29).
NOTE
Yoke may be used to hold shaft when
installing screws.
(43)
Press bearing (42) to seat against spacer
(41).
WARNING
Adhesive sealant can burn easily,
can give off harmful vapors, and is
harmful to skin and clothing. To
avoid injury or death, keep away from
open fire and use in well-ventilated
area. If adhesive-sealant gets on skin
or clothing, wash immediately with
soap and water.
(44)
Coat threads of two screws (43) with
adhesive-sealant (Item 5, Appendix B).
(45)
Install new piston ring (44) and pump
drive plate (45) on input shaft (29) with
screws (43). Torque to 60 lb-ft (81 Nm).
23-21
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals