FOURTH CLUTCH REPAIR (CONT) -726030232

TM 9-2320-360-34-2

c. Installation

NOTE

Do step (1) only if center support was

not removed.

(1) Install fifth clutch assembly (para 22-9).

(2) Soak friction plates (1) in clean lubricating oil for

2 minutes.

NOTE

Thick steel plates (color-coded

green) must be installed on bottom of

stack.

(3) Install steel plate (2) (color-coded green) with

gap (3) facing as shown.

NOTE

All steel plates and backplate must

align with gap noted in step (3).

(4) Install four friction plates (1) and three steel

plates (2), starting with friction plate (1) and

alternating with steel plate (2).

(5) Install backplate (4).

WARNING

Wear eye protection and use care

when installing retaining rings.

Retaining rings are under spring

tension and can act as projectiles

when released causing severe eye

injury.

(6) Install retaining ring (5) with gap opposite oil pan

side (6) of transmission housing (7).

d. Follow-On Maintenance

Install forward clutch assembly and turbine shaft (para

22-55