 |
|||
|
|
|||
|
Page Title:
CAMSHAFT AND END BEARING REPAIR (Cont.) |
|
||
| ||||||||||
|
|
 TM 9-2320-360-34-2
(3) Align left camshaft gear (4), right camshaft
gear (5), idler gear (6), and crankshaft
timing gear (7) so timing marks on gears
line up as shown.
(4) Slide camshaft gears (4 and 5) in place
until camshaft gears and idler gear (6) are
fully meshed.
(5) Check timing marks again to ensure gears
(4, 5, 6, and 7) are aligned as shown.
(6) Turn gear (5) to reach all rear end bearing
screw holes.
(7) Install three new lockwashers (8) and
screws (9) on each camshaft rear end
bearing (10 and 11) and engine block (2).
Torque to 40 lb-ft (54 Nm).
(8) Align holes in three Intermediate bearings
(12) on right and left camshafts (1 and 3)
with tapped holes in engine block (2).
(9) Install six lock screws (13 ). Torque to 240
lb-in. (27.1 Nm).
19-109
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals