FRONT END PLATE REPAIR (CONT) -726030044

TM 9-2320-360-34-2

NOTE

Camshaft

end

bearings

are

temporarily Installed to align front

plate.

Holes in front end plate for

camshaft end bearings are not the

same size.

Smaller hole is

accurately machined for alignment

purposes and is always located on

right side of engine as viewed

from the rear.

(6) Install two camshaft end bearings (9) into front

end plate (2) and engine block (5).

(7) Tighten five screws (6) to 31-35 lb-ft (41-47

Nm).

(8) Tighten two screws (8) to 71-75 Ib-ft (96-102

Nm).

(9) Remove two end bearings (9) from front end

plate (2) and engine block (5).

c. Follow-On Maintenance

(1) Install camshafts and end bearings (para 19-12).

(2) Install flywheel housing (para 19-9).

(3) Install flexplate assembly (para 3-17).

(4) Install oil pan (para 3-20).

(5) Install cylinder heads (para 3-10).

(6) Install SRS/TRS sensor (para 3-7).

(7) Install injectors (para 4-2).

(8) Install rocker arms (para 3-18).

(9) Install engine brake retarders (para 3-26).

(10) Install engine brake retarder wire harnesses (para 6-16).

(11) Install blower accessory drive hub (para 4-9).

(12) Install water pump drive gear (para 3-24).

(13) Install vibration damper and front cover (para 3-15).

(14) Install water pump (para 5-5).

(15) Install secondary fuel filter head (para 4-13).

(16) Install right thermostat housing (para 5-4).

(17) Install left thermostat housing (para 5-3).

19-29