|
| |
TM 9-2320-360-34-1
11-2. BRAKE SHOE REPAIR
This task covers
a. Disassembly
c. Assembly
b. Cleaning/Inspection
INITIAL SETUP
Equipment Conditions
Materials/Parts
Brake shoes on dean work surface.
Solvent, Dry Cleaning (Item 54, Appendix B)
Lining, Brake (Item 74, Appendix F)
Tools and Special Tools
Tool Kit, Genl Mech (Item 202, Appendix E)
Brush, Wire (Item 14, Appendix E)
Caliper, Vernier (Item 16, Appendix E)
Drill, Electric, Portable (Item 34, Appendix E)
Drill Set, Twist (Item 33, Appendix E)
Goggles, Industrial (Item 57, Appendix E)
Reliner, Brake and Clutch (Item 128,
Appendix E)
Vise, Machinists (Item 207, Appendix E)
a.
Disassembly
WARNING
Brake shoes may be coated with
dust. Breathing dust may be harmful
to
personnel.
Do
not
use
compressed air to clean brake shoes.
Wear filter mask approved for use
against dust.
NOTE
There are two brake linings per brake
shoe. Both linings are removed the
same way.
(1)
Position brake shoe (1) in vise.
WARNING
Wear goggles when drilling out
rivets. Failure to comply may result
in injury to personnel.
(2)
Drill out 14 rivets (2) from brake lining (3).
(3)
Remove brake lining (3) from brake shoe
(1).
(4)
Repeat steps (1) thru (3) for remaining
brake shoes.
11-2
|
