|
| |
TM 9-2320-360-34-1
Check connectors at SRS (both harness side and
SRS side) for damage; bent, corroded, and
unseated pins or sockets, or bad contacts.
(1) Turn ENGINE switch OFF.
(2) Install ECM (TM 9-2320-360-20).
(3) Reconnect all connectors.
(4) Turn ENGINE switch ON and clear codes.
(5) Start and run engine until, CHECK ENGINE
indicator lights for 1 minute.
(6) Stop engine and read historical codes.
WARNING
Jewelry can catch on equipment and
cause injury or short across electrical
circuit and cause severe burns or
electrical
shock.
Remove
rings,
bracelets, watches, necklaces, and any
other jewelry before working around HET
Tractor.
CAUTION
Use jumper wire only between terminals
indicated. Failure to comply may result in
damage to DDEC components or wiring.
NOTE
Refer to Appendix C, (Illustrated List of
Manufactured Items) for fabrication of
jumper harness.
(1) Turn ENGINE switch OFF.
(2) Connect 12 volts from a fully charged battery
to 6-pin power connector
(3) Connect other connector.
(4) Turn ENGINE switch ON and clear codes.
(5) Start engine and run for one minute or until
CHECK ENGINE indicator lights.
(6) Stop engine and read active codes.
2-27
|
