|
| |
TM 9-2320-360-34-1
CAUTION
Use jumper wire only between
terminals indicated. Failure to
comply may result in damage to
DDEC components or wiring.
CONTINUITY TEST
(1) Install a jumper wire between sockets
A and B of SRS harness connectors.
(2) Read resistance between sockets S1
and S2 of engine harness connector.
CONTINUITY TEST
Read resistance of the SRS
across sensor pins A and B.
Check connectors at TRS (both harness side
and TRS side) for damage; bent, corroded,
and unseated pins or sockets, or bad
contacts.
2-25
|
