|
| |
TM 9-2320-360-34-1
(8)
If any calibration code on display is different from calibration code on replaced injector for that cylinder,
press FUNCTION to return to "CAL UPDATE" menu.
(9)
From "CAL UPDATE" select [UPDATE] and press ENTER.
(10)
Type four-digit "Update Injector Calibration" password for DDR and press ENTER. This feature is not
password protected, type "0000" and press ENTER.
(11)
An information message will appear telling you to use UP and DOWN arrow keys to select FUNCTION,
LEFT and RIGHT arrow keys to change option, and TYPE # (injector calibration code). Press ENTER.
(12)
An asterisk (*) will highlight first cylinder number in list. Scroll to cylinder requiring change and type in new
two-digit injector calibration code number. Press ENTER.
NOTE
ENTER key must be pressed before DDR will allow selection of another cylinder
number.
(13)
When all cylinders have been updated with required calibration code numbers, press FUNCTION key.
(14)
Select [YES] from display and press ENTER to reprogram ECM with revised injector calibration codes.
NOTE
Engine may be started immediately after inputting injector calibration data.
Change 3 4-2.3
|
