|
| |
TM 9-2320-360-34-1
(b)
Display Menu Commands. The commands in this section allow the operator to control the data that is
being displayed.
1. Start.
The start command allows the user to start the display data after it has been stopped for
viewing. The command only affects the data which is being displayed.
2. Stop.
The Stop command allows the user to stop the constantly changing display data. This
allows the operator to freeze the display and study the data.
3. Clear.
The Clear command allows the operator to clear the data values from the various
readouts. New data will be displayed as it becomes available.
(c)
Log Menu Commands. The commands in this section allow the operator to control the various log
functions. The operator may play back a previously recorded log, or may create a new log to store
incoming data. This function is not used in the HET M1070 troubleshooting.
(d)
Diagnostics Menu Commands. The commands in this section allow the operator to view the alarms
(active codes) and work the status diagnostics.
1. Alarms (Active Codes). The Alarms command allows the operator to view all the systems alarms
(active codes). When this command is selected, the Current Alarms window is displayed.
This window will display all alarms (active codes) that have been detected since system
start up or the last time this window was cleared. From this window, the operator can
also set the alarm priority for both the Pop-up Window and the Beep Alarm.
2. Status.
Not applicable.
Change 2 2-7
|
