|
| |
TM 9-2320-360-34-1
3-3. ENGINE/TRANSMISSION ASSEMBLY REPLACEMENT (CONT)
(54)
Install front shaft (120) on rear shaft (121).
(55)
Install two new U-bolts (122), four new
lockwashers (123), and new nuts (124) on
universal joint (125). Torque to 13-18 lb-ft
(18-24 Nm).
(56)
Install key (126) on PTO output shaft
(118).
(57)
Install yoke (119) on PTO output shaft
(118).
WARNING
Adhesive-sealant can burn easily,
can give off harmful vapors, and is
harmful to skin and clothing. To
avoid Injury or death, keep away from
open fire and use in well-ventilated
area. If adhesive sealant gets on skin
or clothing, wash immediately with
soap and water.
(58)
Coat
threads
of
screw
(127)
with
adhesive-sealant.
(59)
Install screw (127) on yoke (119).
NOTE
·
When
tie
rods
are
properly
installed there should be 1.75 in.
(4.45 cm) between top of radiator
and hardlift bracket.
·
Do not use nuts on large end of
mount to tighten. Only use nuts
on small end to tighten and
mushroom mount.
(60)
Back off two inside nuts (128) on tie rods
(129) from two tie rod supports (130) to
allow radiator (131) to tilt back.
(61)
Tighten two outside nuts (132) on tie rods
(129) against tie rod supports (130).
(62)
Tighten two inside nuts (128) on tie rods
(129) against tie rod supports (130).
3-32
|
