|
| |
TM 9-2320-360-34-1
VOLTAGE TEST
WARNING
Remove all jewelry such as rings, dog tags, and
bracelets. If jewelry contacts electrical terminals a
direct short may result in instant heating of tools,
damage to equipment, and injury to personnel.
(1) Remove winch control console panels (TM 9-2320-360-20).
(2) Remove two wires from counterbalance valve solenoid.
(3) Turn ENGINE switch to ON (TM 9-2320-360-10).
(4) Push PTO switch to ON position (TM 9-2320-360-10).
(5) Position WINCH SPEED CONTROL switch to HIGH
(TM 9-2320-360-10).
(6) Place negative (-) probe of meter on ground.
NOTE
Voltage will only be measured at one wire; the other
wire is a ground wire.
(7) Place positive (+) probe of meter on each wire terminal and
observe voltage on meter,
(8) Position WINCH SPEED CONTROL switch to LOW
(TM 9-2320-360-10).
(9) Push PTO switch to OFF position (TM 9-2320-360-10).
(10)Turn ENGINE switch to OFF (TM 9-2320-360-10).
CONTINUITY TEST
CAUTION
Electrical
power
must
be
disconnected from circuit before
continuity con be checked. Failure
to comply may result in damage to
test
equipment
or
electrical
system.
(1) Place negative (-) probe of meter on one
terminal of solenoid valve coil.
(2) Place positive (+) probe of meter on other
terminal of solenoid valve coil and observe
ohms reading on meter.
2-181
|
