|
| |
TM 9-2320-360-34-1
Refer to para 13-8 for instructions on checking and adjusting
steering system.
RELIEF PRESSURE TEST
(1) Start engine (TM 9-2320-360-10).
CAUTION
Closing the load valve will drop the flow to
zero and put the pump into relief. This should
be limited to 10 seconds. Failure to comply
may cause equipment damage.
(2) Slowly close the load valve and observe pump relief
pressure. Open the load valve.
NOTE
Turning set screw clockwise will increase
pressure. Turning set screw counterclockwise
will decrease pressure.
(3) Turn slotted set screw plunger on front steering pump
compensator to adjust pressure.
(4) Push down the load valve lever.
(5) Shut off engine (TM 9-2320-360-10).
(6) Remove hose from steering gear and hydraulic sys-
tems tester.
(7) Remove hose no. 2301 form hydraulic systems tester
and install on steering gear.
RELIEF PRESSURE TEST
(1) Start engine (TM 9-2320-360-10).
CAUTION
Closing the load valve will drop the flow to zero
and put the pump into relief. This should be
limited to 10 seconds. Failure to comply may
cause equipment damage.
(2) Slowly close the load valve and observe pump relief
pressure. Open the load valve.
NOTE
Turning set screw clockwise will increase
pressure. Turning set screw counterclockwise
will decrease pressure.
(3) Turn slotted set screw plunger on rear steering pump
compensator to adjust pressure.
(4) Push down the load valve lever.
(5) Shut off engine (TM 9-2320-360-10).
(6) Remove hose from steering gear and hydraulic systems
tester.
(7) Remove hose no. 2275 form hydraulic systems tester
and install on steering gear.
2-163
|
