|
| |
TM 9-2320-360-34-1
RELIEF PRESSURE TEST
(1) Start engine (TM 9-2320-360-10).
CAUTION
Closing the load valve will drop the
flow to zero and put the pump into
relief. This should be limited to 10
seconds. Failure to comply may
cause equipment damage.
(2) Slowly close the load valve and observe pump relief
pressure. Open the load valve.
NOTE
Turning set screw clockwise will
increase pressure. Turning set
screw
counterclockwise
will
decrease pressure.
(3) Turn slotted set screw plunger on front steering
pump compensator to adjust pressure.
(4) Push down the load valve lever.
(5) Shut off engine (TM 9-2320-360-10).
(6) Remove hose from steering gear and hydraulic
systems tester.
(7) Remove hose no. 2301 form hydraulic systems
tester and install on steering gear.
RELIEF PRESSURE TEST
(1) Start engine (TM 9-2320-360-10).
CAUTION
Closing the load valve will drop
the flow to zero and put the pump
into relief. This should be limited
to 10 seconds. Failure to comply
may cause equipment damage.
(2) Slowly close the load valve and observe pump
relief pressure. Open the load valve.
NOTE
Turning set screw clockwise will
increase pressure. Turning set
screw
counterclockwise
will
decrease pressure.
(3) Turn slotted set screw plunger on rear steering
pump compensator to adjust pressure.
(4) Push down the load valve lever.
(5) Shut off engine (TM 9-2320-360-10).
(6) Remove hose from steering gear and hydraulic
systems tester.
(7) Remove hose no. 2275 form hydraulic
systems tester and install on steering gear.
2-149
|
