|
| |
TM 9-2320-360-34-1
STEERING GEAR MOUNTING
SCREWS INSPECTION
(1) Inspect front and rear steering gear for
loose mounting screws.
NOTE
If screws are loose, do
steps (2) thru (4).
(2) Remove front and/or rear steering gear
(para 13-5 and/or 13-6).
(3) Inspect for damage to mounting screw
holes or damage to screws from
operating while loose.
(4) Install front and/or rear steering gear
(para 13-5 and/or 13-6).
STEERING TEST
(1) Remove wheel and tire assemblies from no. 1 and no. 4
axles (TM 9-2320-360-20).
(2) Remove no. 1 and no. 4 axle tie rods (TM 9-2320-360-20).
(3) Remove front and rear draglinks (para 13-2 and para 13-3).
(4) Using a torque wrench connected to steering arm, measure
the amount of force required to move all spindles through
their full range of motion.
(5) Install no. 1 and no. 4 axle tie rods (TM 9-2320-360-20).
(6) Install front and rear draglinks (para 13-2 and para 13-3).
(7) Install no. 1 and no. 4 axle wheel and tire assemblies
(TM 9-2320-360-20).
2-143
|
