|
| |
TM 9-2320-360-34-1
WARNING
Wear approved eye protection when
performing transmission pressure
checks. Failure to comply may result
in oil getting into eyes. If oil contacts
eyes,
seek
medical
attention
immediately.
REAR GOVERNOR PRESSURE
TEST
(1) Remove plug from rear governor test port.
(2) Install 0-160 psi (0-1103 kPa) pressure
gage on rear governor test port.
(3) Remove lower engine access panel
(TM 9-2320-360-20).
(4) Route pressure gage and hose thru
doghouse.
(5) Start engine (TM 9-2320-360-10).
(6) Position transmission range selector to 2-5
position.
(7) Release parking brake
(TM 9-2320-360-10) and drive vehicle.
(8) Check reading on pressure gage when
rpm reaches 1650, in 5th gear at
approximately 35 mph with aid of assistant
(9) Shut off engine (TM 9-2320-360-10).
(10)Remove pressure gage from rear governor
test port.
(11)Install plug on rear governor test port.
(12)Install lower engine access panel
(TM 9-2320-360-20)
INTERNAL FILTER ELEMENT
INSPECTION
(1) Remove oil pan (para 7-5).
(2) Remove plug and governor oil filter
screen.
(3) Check internal filter element and oil filter
screen for restrictions.
(4) Install governor oil filter screen and plug.
(5) Install oil pan (para 7-5).
Change 2 2-111
|
