|
| |
TM 9-2320-360-34-1
WARNING
Wear
approved
eye
protection
when
performing transmission pressure checks.
Failure to comply may result in oil getting into
eyes. If oil contacts eyes, seek medical
attention immediately.
MAIN PRESSURE TEST
(1) Remove main pressure oil line no. 2672 from
main pressure port on transmission converter
housing.
(2) Install tee, 0-2000 psi (0-13,790 kPa) gage and
main pressure oil line no 2672 in main pressure
port on converter housing.
(3) Start engine (TM 9-2320-360-10) and run at idle.
(4) With parking brake applied, position transmission
range selector to 2-5 position.
WARNING
Do not stand in front of HET when testing
main pressure. Brakes may release and
vehicle could move causing personal injury
or death.
(5) Check reading on pressure gage.
(6) Shut off engine (TM 9-2320-360-10).
(7) Remove pressure gage from main pressure oil
line and install main pressure oil line on main
pressure port.
INTERNAL FILTER ELEMENT
INSPECTION
(1) Remove oil pan (para 7-5).
(2) Check internal filter element for damage or
restrictions.
PICKUP TUBE PREFORMED
PACKING INSPECTION
(1) Remove internal filter element (para 7-7).
(2) Inspect condition of internal filter
preformed packing.
(3) Install internal filter element (para 7-7).
2-105
|
