|
| |
TM 9-2320-360-34-1
DRIVE LINE CHECK
(1) Remove propeller shaft from transmission
output shaft (TM 9-2320-360-20).
(2) Start engine (TM 9-2320-360-10) and
shift transmission range selector through
all ranges.
(3) Listen for unusual noises.
(4) Install propeller shaft on transmission
output shaft (TM 9-2320-360-20).
WARNING
Wear
approved
eye
protection
when
performing
transmission
pressure
checks.
Failure
to
comply may result in oil getting
into eyes. If oil contacts eyes, seek
medical attention immediately.
LUBRICATION SYSTEM
PRESSURE TEST
(1) Remove plug from lubrication port on
converter housing.
(2) Install 0-160 psi (0-1103 kPa) pressure
gage on bottom of converter housing.
(3) Start engine (TM 9-2320-360-10) and
operate at 1900 to 2100 rpm.
(4) Check reading on pressure gage.
(5) Shut off engine (TM 9-2320-360-10).
(6) Remove pressure gage from converter
housing.
(7) Install plug in transmission lubrication port.
2-103
|
