|
| |
TM 9-2320-360-34-1
WARNING
Wear approved eye protection when
performing
transmission
pressure
checks. Failure to comply may result in
oil getting into eyes. If oil contacts eyes,
seek medical attention immediately.
LUBRICATION SYSTEM
PRESSURE TEST
(1) Remove plug from lubrication port on
converter housing.
(2) Install 0-160 psi (0-1103 kPa) pressure
gage on bottom of converter housing.
(3) Start engine (TM 9-2320-360-10) and
operate at 1900 to 2100 rpm while assistant
checks reading on pressure gage.
(4) Shut off engine (TM 9-2320-360-10).
(5) Remove pressure gage from converter
housing.
(6) Install plug in transmission lubrication port.
MAIN PRESSURE TEST
(1) Remove main pressure oil line no. 2672
from main pressure port on transmission
converter housing.
(2) Install tee, 0-2000 psi (0-13,790 kPa)
pressure gage, and main pressure oil line
no. 2672 in main pressure port on
converter housing.
(3) Start engine (TM 9-2320-360-10) and run
at idle.
(4) With parking brake applied, position
transmission range selector to 2-5 position
while assistant checks reading on pressure
gage.
(5) Shut off engine (TM 9-2320-360-10).
(6) Remove pressure gage from main
pressure oil line and install main pressure
oil line on main pressure port.
2-99
|
