|
| |
TM 9-2320-360-34-1
WARNING
Ensure engine is cool
before
performing
maintenance. Failure to
comply
may
result
in
severe burns.
ENGINE BRAKE
RETARDER WIRING
HARNESS TEST
(1) Remove engine brake retarder
wire harness from affected
cylinder head (para 6-16).
(2) Set multimeter to ohms position.
(3) Connect multimeter leads to
wire harness connectors.
(4) Observe resistance reading
displayed on multimeter.
(5) Remove multimeter leads from
connectors.
ENGINE BRAKE
RETARDER WIRING
HARNESS TEST
(1) Set multimeter to ohms position.
(2) Connect multimeter leads to
solenoid terminal and known
good ground.
(3) Observe resistance reading
displayed on multimeter.
(4) Remove multimeter leads from
terminal and ground.
(5) Install engine brake retarder wire
harness (para 6-16).
2-95.2 (2-96 blank)
|
