|
| |
TM 9-2320-360-34-1
(1)
Fabricate from 3 in. (7.6 cm) OD steel tube.
(2)
Using hacksaw, cut tubing to 6 1/2 in. (16.5 cm) in length.
(3)
Cut 3 in. (7.6 cm) diameter circle from 1/2 in. (1.3 cm) steel plate.
(4)
Weld steel plate on one end of steel tube.
(5)
Using file or grinder, remove any sharp edges.
(6)
All dimensions are in inches (centimeters).
Figure C-20. Pinion Bearing Cone Installer (PN 2HE491)
(1)
Fabricate from 4 in. (102 cm) OD steel tube.
(2)
Using hacksaw, cut tubing to 4 1/4 in. (10.8 cm) in length.
(3)
Cut 4 in. (10.2 cm) diameter circle from 1/2 in. (1.3 cm) steel plate.
(4)
Weld steel plate on one end of steel tube.
(5)
Using file or grinder, remove any sharp edges.
(6)
All dimensions are in inches (centimeters).
Figure C-21. Power Divider Bearing Cone Installer (PN 2HE497)
Change 1 C-15
|
