|
| |
TM 9-2320-360-34-1
(1)
Fabricate from 3/8 in. -16 threaded steel rod.
(2)
Using hacksaw, cut rod to 5 in. (127 mm) length.
(3)
Using file or grinder, remove any sharp edges.
(4)
Using hacksaw, cut screwdriver-size notch in one end of rod.
(5)
All dimensions are in inches (millimeters).
Figure C-14. Threaded Rod (3/8 inch)
(1)
Fabricate from 1/2 in. (13 mm) thick mild steel stock.
(2)
Using torch, cut steel stock to dimensions shown.
(3)
Using grinder, remove rough edges.
(4)
All dimensions are in inches (millimeters).
Figure C-15. Yoke Holder (PN 2HD798)
C-9
|
