|
| |
TM 9-2320-360-34-1
NOTE
Flat surface of thrust ring faces out.
(9)
Install thrust ring (12) on clutch drive gear
(5).
(10)
Install bearing (13) on shaft (14).
(11)
Install spring (15) on clutch adapter (2).
(12)
Install new preformed packing (16) on
clutch end cover (17).
(13)
Install two threaded rods (18) on opposite
ends of clutch adapter (2).
(14)
Install clutch end cover (17) on threaded
rods (18).
(15)
Install two nuts (19) on threaded rods (18).
Tighten until mating surfaces of clutch end
cover (17) and clutch adapter (2) meet.
(16)
Install four new lockwashers (20) and
screws (21) on clutch end cover (17).
17-35
|
