|
| |
TM 9-2320-360-34-1
b.
Cleaning/inspection
WARNING
Dry cleaning solvent P-D-680 is toxic and flammable. Wear protective goggles and
gloves and use solvent only in a well-ventilated area. Avoid contact with skin,
eyes, and clothes, and don't breathe vapors. Do not use near open flame or
excessive heat. The flash point Is 100-138° F (38-59° C). If you become dizzy while
using cleaning solvent, get fresh air immediately and get medical aid. If solvent
contacts eyes, wash eyes with water and get medical aid immediately.
(1)
Clean all parts with dry cleaning solvent.
WARNING
Compressed air for cleaning purposes will not exceed 30 psi (207 kPa). Use only
with effective chip guarding and personal protective equipment (goggles/shield,
gloves, etc.).
(2)
Dry all parts, except bearings, with compressed air.
(3)
Inspect piston and clutch adapter for scratches or scoring.
(4)
Inspect bearings for corrosion, scoring pitting, binding, or other damage.
(5)
Remove all nicks and burrs from machined surfaces.
(6)
Replace all worn or damaged parts.
c.
Assembly
WARNING
Adhesive-sealant can bum easily, can
give off harmful vapors, and is
harmful to skin and clothing. To
avoid injury or death, keep away from
open fire and use in well-ventilated
area. If adhesive sealant gets on skin
or clothing, wash immediately with
soap and water.
(1)
Coat threads of two fittings (1) with pipe
thread sealing compound.
(2)
Install two fittings (1) in clutch adapter (2).
17-33
|
